You can connect Claude to Communal using the Model Context Protocol (MCP).
Before you begin
Make sure you have your Communal connection URL available.
For example:
Before you begin
Make sure you have your Communal connection URL available.
For example:
https://your-communal-url.com/MCP
The URL will not work correctly if
/MCPis omitted from the end.
Add the MCP connection
1. Open Claude.
2. Go to Settings and add a Custom Connector
3. Enter your Communal connection URL.
4. Add
5. Save the connection and complete any authentication steps Claude prompts you to follow.
Troubleshooting
If Claude cannot connect:
- Confirm that the URL is correct.
- Check that
- Make sure you completed the authentication prompt.
- Try removing and re-adding the connection.
1. Open Claude.
2. Go to Settings and add a Custom Connector
3. Enter your Communal connection URL.
4. Add
MCP to the end of the URL.5. Save the connection and complete any authentication steps Claude prompts you to follow.
Troubleshooting
If Claude cannot connect:
- Confirm that the URL is correct.
- Check that
MCP appears at the very end of the URL.- Make sure you completed the authentication prompt.
- Try removing and re-adding the connection.